• Home
    • EMPLOYEE LOGIN
  • Accessories
    • Fuel Fittings
    • Fuel Line
    • Servos >
      • OMG Servos Close Out Prices!!!
    • BATTERIES
    • Stihl Ultra HP
    • GP to DA Adapters
    • Choke Arm
    • Walbro Throttle Arm
    • JC23/30 Prop Adapter
    • CONNECTORS
    • MISC.
    • V-RC Apparel
    • Bunk Works Puller
  • CONTACT INFO
  • WIKI
  • V-RC Pilots
  • Booma RC
  • VRC Racer

JC120 Throttle Arm Install

Picture
This article will guide you through install steps to add the new factory jc120 arm to your current engine.

First off open the package and lay it out.

Picture
Lay  the arm up to the WJ71, You must insert the arm from the bottom side so the 
JC arm notch stops on Walbro stock arm.

Picture
Insert  the bolt through the backside of the carb arm and place washer on the JC throttle arm.

Picture
Add locktite! 

Picture
Install supplied nut and tighten so its touching the washer.

Picture
Now the fun part, if you're wanting to install arms with out taking off the carb this is how you do it. You will need a "straight" screw driver and nut driver. Tighten nut until arm is thoroughly secured and does rock on stock walbro arm. There you guys, so easy a cave man could do it!

Powered by Create your own unique website with customizable templates.